SIG SAUER P238 / P938, Colt Mustang, Kimber Micro 9 - Custom Aerospace Grade Aluminum Flat  Adjustable Trigger
	
		
			
			
A direct replacement to your stock trigger for a smmother, more consistent pull.
			
 
			
-  This is the SKELETON version 
			
SOLID version also available - CLICK HERE
			
 
			
SIG Performance Custom Trigger For the SIG SAUER P238 / P938 Colt Mustang , Mustang II, Colt Pocketlite & Colt Mustang XSP
			
 
			
-  Metal construction (Aerospace grade 6061-T651 Cold Finish anodized aluminum vs. factory plastic) Plastic must be “OK” if SIG dares to use it for triggers in their guns but plastic triggers do NOT belong on a higher end  all metal pistol. It was simply a cost saving measure by SIG Sauer.
			
			-  Optimized for *length*. Many shooters will say that the stock trigger could have been a hair longer as it uncomfortably pinches their trigger finger against the trigger guard (especially during rapid fire) as their finger can get positioned too low inadvertently. This design is a HUGE benefit/improvement !
			
			-  Optimized for *width*. More tight and with less ‘side-to-side’ wiggle vs. stock trigger.
			
			-  Straight trigger surface with grooves. Promotes better trigger discipline  - i. e. more accuracy (especially during rapid fire, which could happen in a self-defense situation.
			
 
			
-  Over-travel adjustments /elimination! Faster reset and more accuracy during rapid fire 
			
 
			
-    These triggers do not fit the CA Compliant models.
			
-    Although these are drop in ready, triggers should be installed by qualified gunsmiths only.
			
-   MADE IN USA
			
-   Facility certified to ISO 9001/AS9100 & in accordance with the requirements of AS9104A.
			
 
			
All triggers, hammers or any other gun parts are intended for installation by a gunsmith or a qualified armorer.